Troubleshooting and Maintaining Cisco IP Networks
Which of the following characteristics describe the BPDU Guard feature? (Choose all
A. A BPDU Guard port should only be configured on ports with PortFast enabled.
B. BPDU Guard and PortFast should not be enabled on the same port.
C. BPDU Guard is used to ensure that superior BPDUs are not received on a switch port.
D. A BPDU Guard port receiving a BPDU will go into err-disable state.
E. A BPDU Guard port receiving a BPDU will be disabled.
F. BPDU Guard can be enabled on any switch port.
Answer: A, E
Which of the following are valid modes of accessing the data plane? (Choose all that
A. Serial connection
B. Secure Shell
D. Simple Network Management Protocol
E. HTTP F. Telnet
Answer: A, B, D, E, F
Which of the following is not an essential prerequisite for AutoQoS to be correctly
applied to an interface? (Choose all that apply.)
A. The interface must be configured as a Multilink PPP interface.
B. The correct bandwidth should be configured on the interface.
C. A QoS policy must not be currently attached to the interface.
D. CEF must be enabled.
E. AutoQoS must be enabled globally before it can be enabled on the interface.
F. An IP address must be configured on the interface if its speed is equal to or less than
Answer: A, E
Which of the following topology situations would be a qood candidate for configuring
A. Extranet VPN
B. Managed overlay VPN topology
C. Hub-and-spoke VPN topology
D. Central-site VPN topology
E. Full mesh VPN topology
F. Remote-access VPN topology
Which of the following is not considered a common approach to narrow the field of
potential problem causes? (Choose the best answer.)
A. Following the traffic path
C. Comparing configurations
E. Divide and conquer
F. Examine SLAs