APPLICATOR INFORMATION AND M.S.D.S.
General Application Instructions
Please refer to Monoglass® Applicator Manual for
complete details. Call 1-888-777-2966 to request a
copy of this 14-page informational booklet.
These instructions have been prepared to assist
Monoglass® installing contractors in their efforts
to provide quality workmanship in the field appli-
cation of Monoglass® products.
Our published data reflects independent test
results. However, due to variables in field condi-
tions and equipment performance Monoglass®
Incorporated does not guarantee any specific cov-
erage. Liability, if any, is limited to replacement of
defective material only.
2.1 Recommended spray machine
The recommended application machine is the
Polyspray C-500 manufactured by Unisul Inc. of
Winter Haven, Florida. This equipment incorpo-
rates features required to achieve maximum yield
2.2 Other machines
A number of fiber machines designed for cellu-
lose, fiberglass, mineral wool insulation & fire-
proofing products can be used to spray
Monoglass®. Machines commonly used include
Krendl, Unisul, AccuOne, Boss, Heat Seal and
FiberKing. Contact your machine manufacturer or
2.3 Required additional equipment
For all equipment types, you will require a
Monoglass® spray head to ensure proper finish.
You will also require 200 ft (60 meters) of 2 inch
[50 mm] light plastic delivery hose, one 500 p.s.i.
adhesive pump, 200’ (60 meters) of tested burst
500 p.s.i. liquid line, 2 x 45 imperial gallon [55 US
gallon] [200 litre] plastic drums, 110 and 220
power cords and water hose with nozzle.
2.4 Recommended jobsite equipment
Particulate dust masks and safety equipment as
described in product M.S.D.S., set of tools, polyeth-
ylene sheeting, duct tape, lighting, brooms and
clean up equipment.
3.1 Site considerations
Assure adequate electrical power, clean water and
sufficient lighting. Ambient and substrate tempera-
tures shall not be below 1ºC