101 89 44-26
335 XPT
Workshop Manual
2 – English
CONTENTS
Introduction ....................................................3
Safety instructions .........................................4
Key to symbols ...............................................5
Technical data.................................................6
Tools ................................................................8
Trouble shooting ..........................................10
Service data ..................................................12
Safety equipment .........................................14
Starter ............................................................19
Ignition system .............................................21
Centrifugal clutch .........................................23
Carburettor....................................................25
Tank unit........................................................33
AV-System .....................................................37
Crankshaft, Piston and Cylinder ................ 38
Bar bolt ..........................................................42
Oil pump........................................................43
Eng 02-09
97-12-03, 16.26
2
English – 3
INTRODUCTION
Layout
This workshop manual can be used in two different ways:
• Reparation of a particular system on the chain saw.
• Dismantling and Assembling the entire chain saw.
General
This workshop manual describes in detail how trouble shooting,
repairs and testing of the chain saw should be carried out. The
different safety precautions that must be taken when carrying
out repairs are also described.
Dismantling and assembling the
entire chain saw
When the entire chain saw shall be stripped and rebuilt proceed
as follows:
1. Turn to page 19, which deals with the Starter and carry out
the instructions under the heading Dismantling.
2. Go forward in the manual and carry out Dismantling in the
order the sections appear.
3. Return to the Starter on page 19 and carry out the instruc-
tions under Cleaning and inspection.
4. Work fo