TM2152 - 317 and 320 Skid Steer Loader CT322 Compact Track Loader
Front or Rear Idler Remove and Install
Front or Rear Idler Remove and Install
1. Park machine on a flat level surface.
2. Raise and block compact track loader. See Raising and Blocking Machine . (Operator's Manual.)
3. Remove rubber track. See Rubber Track Remove and Install . (Group 0130.)
4.
CAUTION:
Heavy component; use a hoist.
CAUTION:
Support idler (1) before removing cap screws (2). Idler will drop once cap screws have been removed.
Remove cap screws (2) holding idler (1) in place.
T212588A-UN: Front Idler Remove and Install
Item
Measurement
Specification
Front or Rear Idler
Weight
33.5 kg (74 lb) approximate
1/2
2019/11/23
file:///C:/ProgramData/Service%20ADVISOR/Temp/TM2152_09001faa8026...
T212249A-UN: Rear Idler Remove and Install
LEGEND:
1 - Idler
2 - Cap Screw (2 used)
3 - Track Frame
5. Using a shop hoist, remove idler from track frame.
6. Repair or replace as necessary. See Front or Rear Idler Disassemble and Assemble . (Group 0130.)
7. Apply threadlock and sealer (medium strength) to threads of cap screws.
8.
Install rear idler into track frame.
9. Tighten cap screws.
10.
Install rubber track. See Rubber Track Remove and Install . (Group 0130.)
11. Adjust track sag. See Check and Adjust Track Sag . (Group 9020-25.)
12. Raise machine and remove blocking. See Raising and Blocking Machine . (Operator's Manual.)
Item
Measurement
Specification
Front or Rear Idler
Cap Screw
Torque
592—696 N·m (437—513 lb-ft)
LOCTITE is a trademark of Loctite Corp.
KK70125,000009A-19-20081111
2/2
2019/11/23
file:///C:/ProgramData/Service%20ADVISOR/Temp/TM2152_09001faa8026...
TM2152 - 317 and 320 Skid Steer Loader CT322 Compact Track Loader
Front or Rear Idler Disassemble and Assemble
Front or Rear Idler Disassemble and Assemble
T210902-UN: Front or Rear Idler
LEGEND:
1 - Snap Ring (2 used)
2 - Plug
3 - Collar (with Plug Hole)
4 - Metal Face Seal (2 used)
5 - O-Ring (2 used)
6 - Axle Shaft
7 - Bushing (2 used)
8 - Idler
9 - Collar
1.