Instructor Notes:
V5 Surfaces
Copyright DASSAULT SYSTEMES
Copyright DASSAULT SYSTEMES
Lesson 3: Surface Creation
In this lesson, you will learn how to create surfaces from wireframes.
Lesson content:
Case Study: Surface Creation
Design Intent
Stages in the Process
Choice of Surface
Sweeping a Profile
Create a Multi-Section Surfaces
Create a Adaptive Sweep Surface
Objectives of the lesson:
- inform on the tools available in the GSD workbench to create surfaces geometry
Load the part “Lesson3.CATPart” for demo
Instructor Notes:
V5 Surfaces
Copyright DASSAULT SYSTEMES
Copyright DASSAULT SYSTEMES
Case Study: Surface Creation
The case study for this lesson is the “Car Door substrate
with Arm rest”. The focus of this case study is the creation of
Surfaces from a given wireframe data to check the Design
feasibility. Your goal is to achieve the editable model of “Car
Door substrate with Arm rest”. which incorporates the design
intent of the part.
The focus of the case study in this lesson is to understand,
how to access Surface Design workbench and to manage a
few basic tools.
The objectives of this case study you will practice at the end of the lesson will enable you
to manipulate the tools seen in the lesson.
Instructor Notes:
V5 Surfaces
Copyright DASSAULT SYSTEMES
Copyright DASSAULT SYSTEMES
Design Intent (1/2)
Create a Door Substrate. The substrate profile needs to be
adaptable for design modification & changes without replacing
the original input .
Create an Adaptive Sweep
Create a broad cross-section surface for an ‘Arm rest’
attached to the front door for design feasibility study.
Create a profile sweep with single guide curve option.
Create a cross-section surface for ‘Key-pad’ (for
Electronic control ) at a measured distance from the Arm rest
ankle point.
Create a profile sweep from a given sketch with single guide
curve.
Attain a single merged part by using Arm rest and the key
pad component.
Create a Multi-section surfac