http://www.prizmshare.com
About Jack Berlin
CEO, Accusoft - jberlin@accusoft.com -
http://www.accusoft.com
fold
back
flaps
flatten
half
open
paper
repeat
side
tulip
turn
http://www.prizmshare.com
About Jack Berlin
CEO, Accusoft - jberlin@accusoft.com -
http://www.accusoft.com
fold
back
flaps
flatten
half
open
paper
repeat
side
tulip
turn
www.origami-fun.com Origami Tulip Instructions 5. Turn the front flap to the left, like turning the pages in a book. Do the same to the other side of the model. 6. Move the upper flaps toward each other, and tuck one into the other, as far as it goes. 7. When you flatten this, make sure the distances A & B shown are equal. 8. Repeat steps 6 & 7 on back of model, to get this. 9. Blow into base of tulip to inflate and shape the flower. 10. Peel each petal down, slowly and carefully. Finished Tulip. Pair with the the Flower Stem. 1. Start with your paper coloured side up. Fold in half, then in half again, as shown. Crease wel, then open out again. 2. Turn the paper over and fold in half diagonally and in both directions. Crease well and open out once again. 4. Fold bottom corners of front flaps up to the top corner. Repeat this on the back as well. 3. Holding the points shown, bring them both down to the centre point on the bottom line. Flatten model. This is called a waterbomb base. diagram is enlarged A B