EZ Directions for the EZ SLOTTER - ctpostandbeam.com
EZ Slotter is recommended for homeowner/contractor limited use with 6"x6" and smaller beams.
We encourage you to watch the 5-minute video on YouTube before using the EZ SLOTTER
to cut your slots for T-REX Connectors at https://youtu.be/jJNMy-2wfcw.
1. Drill a 3/8" hole in your chain saw bar. Center hole in the
middle of the bar, approximately 4" from the motor.
2. Unscrew the nut from the end of the bolt and remove 2
washers. Remove the block by unscrewing 3 screws from the
bottom of the EZ Slotter.
3. Mount chainsaw in EZ Slotter and add the 2 washers that
you previously removed (to make 2 of each side of the bar).
4. Replace
block by reinstalling the 3 screws in the bottom of
the EZ Slotter. Tighten the nut so bar is snug but
moves freely.
5. EZ Slotter is set up for 6"X6" lumber. If you are using a different-
sized T-REX, you will have to remove the wood spacer on the bottom of
the EZ Slotter and replace it with a new spacer to adjust the location of
the saw kerf (slot) so that it will be in the center of your timber.
ctpostandbeam.com