Get a success with an 100% guarantee to pass NACE CIP Level 1 certification NACE-CIP1-001 exam. Killtest NACE-CIP1-001 study guide is dedicatedly designed to help candidates in saving their time and effort required for exam preparation. It offers instant access to study material methods and proven strategies for excelling at certification exam. Killtest is devoted to your success, henceforth pledges you success in NACE NACE-CIP1-001 exam on the first try. Besides, you can check NACE-CIP1-001 free demo questions online with NACE-CIP1-001 NACE CIP Level 1 Free Q&As V8.02.
The safer , easier way to help you pass any IT exams.
1 / 5
1.You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being
applied. After application of the 19 coat you notice small blisters in some areas of the applied lining.
Your FIRST preferred course of action is to:
A. Break the blisters to see what's inside
B. Document the problem and advise the Contractor and Owner's representative
C. Document the problem and advise the Contractor
D. Extract any liquid that may be inside the blister and send it to the lab for further analysis
Answer: B
2.Dew point is the temperature at which
A. water freezes.
B. humidity decreases
C. condensation occurs.
D. the air is saturated.
Answer: C
3.If a contractor is using a poorly maintained compressor to supply air for abrasive blast cleaning and
conventional airspray, the coating inspector should perform a
A. dry film thickness (DEI) measurement.
B. wet film thickness (WFT) measurement.
C. blotter test for the presence of oil and water.
D. vial lest.
Answer: C
4.Upon arrival of coating materials, the inspector should
A. review coating contractors' plans for storage of coating materials and confirm they meet national, local
and owners' fire and environmental regulations.
B. observe and document the amount of material and batch numbers.
C. observe aryl document that the applicator WFT at regular intervals during application.
D. observe and document time frame and environmental conditions between each coat.
Answer: B
5.Relative humidity is
A. a measure of the amount of moisture in the air compared to saturation level.
B. a measure of the amount of moisture in the air compared to the air temperature.
C. the lowest temperature at which moisture forms on a steel surface.
D. the highest temperature at which moisture forms on a steel surface.
Answer: A
6.Galvanic corrosion occurs on which of the following substrates:
A. Concrete
B. Fiberglass Reinforced Plastic
C. Metal
D. Wood
The safe