640-801 CCNA Braindump
ExamSoon 640-801 Exams
Cisco Cisco Certified Network Associate (CCNA)
O rder : 640-801 Exam
Practice Exam: 640-801
Exam Number/Code: 640-801
Exam Name: Cisco Certified Network Associate (CCNA)
Questions and Answers: 212 Q&As
Free 640-801 Braindumps
Exam : CISCO 640-801
Title : CCNA
1. The user of Host1 wants to ping the DSL modem/router at 192.168.1.254. Based on the Host1 ARP table that is
shown in the exhibit, what will Host1 do?
A. send a unicast ARP packet to the DSL modem/router
B. send unicast ICMP packets to the DSL modem/router
C. send Layer 3 broadcast packets to which the DSL modem/router responds
D. send a Layer 2 broadcast that is received by Host2, the switch, and the DSL modem/router
Answer: B
2. Which connections allow the use of full-duplex Ethernet?(Choose three.)
A. switch to host
B. switch to switch
C. hub to hub
D. switch to hub
E. host to host
Answer: ABE
3. Refer to the exhibit. What is the meaning of the term dynamic as displayed in the output of the show frame-relay
map command shown?
A. The Serial0/0 interface is passing traffic.
B. The DLCI 100 was dynamically allocated by the router.
C. The Serial0/0 interface acquired the IP address of 172.16.3.1 from a DHCP server.
D. The DLCI 100 will be dynamically changed as required to adapt to changes in the Frame Relay cloud.
E. The mapping between DLCI 100 and the end station IP address 172.16.3.1 was learned through Inverse ARP.
Answer: E
4. Two routers named Atlanta and Brevard are connected by their serial interfaces as shown in the exhibit, but there is
no data connectivity between them. The Atlanta router is known to have a correct configuration. Given the partial
configurations shown in the exhibit, what is the problem on the Brevard router that is causing the lack of connectivity?
A. A loopback is not set.
B. The IP address is incorrect.
C. The subnet mask is incorrect.
D. The serial line encapsulations are incompatible.
E. The maximum transmission unit (MTU) size is too large.
F. The bandwi