642-731 Others Braindump
ExamSoon 642-731 Exams
Cisco Conducting Cisco Unified Wireless Site Survey
O rder : 642-731 Exam
Practice Exam: 642-731
Exam Number/Code: 642-731
Exam Name: Conducting Cisco Unified Wireless Site Survey
Questions and Answers: 52 Q&As
Free 642-731 Braindumps
Exam : Cisco 642-731
Title : Conducting Cisco Unified Wireless Site Survey
1. If there is an existing 802.11g WLAN at a site, which service can be provided without conducting a new site survey?
A. add a new 802.11a WLAN
B. increase the Layer 2 and Layer 3 security of the WLAN
C. increase the throughput for the wireless clients
D. add new services (such as voice) over the WLAN
Answer: B
2. What are two objectives of a pre-site survey walkthrough? (Choose two.)
A. identify potential problem areas
B. define intended coverage areas
C. assess compliance with local building codes
D. determine the final location of APs and antennas
E. identify sources of RF signal attenuation and RF interference
Answer: AB
3. Which value is NOT supported by Cisco Spectrum Expert, when checking for RF coverage?
A. access point received-signal strength level
B. spectrum utilization
C. client data rate
D. in-band radio frequency interference
Answer: C
4. Which is NOT part of a typical wireless site survey?
A. implementation suggestions
B. access point locations
C. security requirements
D. access point mounting methods
Answer: C
5. Construction of a new automobile parts manufacturing facility has recently been completed. The facility IT manager
wants to deploy voice over WLAN. During your initial walkthrough, you observe numerous highly reflective surfaces on
the manufacturing equipment and in the building construction itself. What potential problem exists that should be
accounted for during your site survey?
A. LOS modulation
B. multipath distortion
C. RF signal absorption
D. RF signal attenuation
E. Fresnel zone impedance
Answer: B
6. To which parameter should the access point be set during a site survey?
A. transmit only
B. diversity
C.