Expert Agilent Keysight Service & Repair
At RestoreRF, we specialize in the service, repair, and restoration of Agilent Keysight test
equipment, ensuring maximum uptime and accuracy for your critical RF and microwave
instruments. Whether you're dealing with a Failed Operators Check, Self Test failure, or
RF Output issues, our certified technicians are equipped with the expertise and tools to
restore your instruments to peak performance.
Failed Operators Check – Diagnosing the Root Cause
A Failed Operators Check often indicates deeper internal faults that may affect
measurement reliability. Our diagnostic process uses factory-grade tools to isolate the issue—
whether it's a defective front panel controller, firmware mismatch, or user interface glitch.
We restore full system functionality and revalidate the unit using OEM-calibrated standards.
Failed Self Test – Precision Troubleshooting
If your Agilent Keysight instrument displays a Failed Self Test, it could point to internal
communication errors, memory corruption, or failing hardware modules. Our team runs full
diagnostics, replacing defective components such as logic boards, IF sections, or RF modules.
Once repairs are complete, we retest the unit under factory conditions to confirm full
functionality.
Failed Self Calibration – Trust in Accurate Results
A Failed Self Calibration can severely impact the accuracy and repeatability of your test
equipment. This failure typically results from temperature compensation circuit issues, aging
reference oscillators, or corrupted calibration constants. RestoreRF provides full recalibration
and alignment services, restoring your unit to meet or exceed original factory specifications.
RF Output Failure – Restoring Signal Integrity
An RF Output Failure can halt critical lab and field operations. Causes range from damaged
RF output stages to attenuator path failure or amplifier circuitry breakdown. At RestoreRF,
we pinpoint the failure using advanced signal path analysis, then replace or repair the faulty
components. Post-repair, we verify output levels, frequency accuracy, and spectral purity.
Channel R1 Failure – Multi-Channel System Recovery
Channel R1 Failures are common in dual-channel spectrum analyzers and vector signal
generators. These may arise from power supply faults, interconnect issues, or ADC converter
problems. Our repair specialists conduct complete cross-channel diagnostics, isolate R1
channel hardware, and perform precision rework or replacement. After repair, each channel is
individually verified and calibrated for accuracy.
Phase Noise Failure – Performance Re-Optimization
Phase noise is a critical parameter for RF systems. A Phase Noise Failure often results from
aging oscillators, degraded power supplies, or faulty phase-locked loops. RestoreRF performs

https://restorerf.com/about-us/

detailed phase noise analysis and component-level testing to ensure that your Agilent
Keysight instrument meets the required noise floor specifications. We fine-tune oscillator
performance to restore original signal clarity and system stability.
Why Choose RestoreRF for Agilent Keysight Repair?
 OEM-Level Diagnostics: We use original Agilent/Keysight tools and procedures.
 Component-Level Repairs: Our technicians repair down to board-level, saving you
the cost of full replacements.
 Calibrated Accuracy: All repaired units go through full calibration and are validated
against NIST-traceable standards.
 Quick Turnaround: Minimize downtime with our efficient testing and repair
processes.
 Industry Experience: Decades of experience in RF, microwave, and electronic test
equipment repair.
Whether you're in aerospace, defense, telecom, or research, our goal is to keep your Agilent
Keysight instruments running with precision and reliability. If you're encountering Failed
Operators Checks, RF Output Failures, or Phase Noise Errors, trust RestoreRF to bring
your equipment back to life.
Contact Us
Visit our service page or get in touch through RestoreRF.com to discuss your repair needs or
request a diagnostic evaluation. We're here to support your lab’s performance—one repair at
a time.