Loading ...
Global Do...
News & Politics
4
0
Try Now
Log In
Pricing
Material Safety Data Sheet Supplier JAX INC. W134 N5373 CAMPBELL DRIVE MENOMONEE FALLS, WI 53051 USA Product Name/ Trade Name JAX CRYOGUARD PLUS ISO 32 Chemical Name Chemical Family Lubricant Hydrocarbon PROPRIETARY FORMULA. This material is essentially hydrotreated petroleum paraffinic mineral lubricating oil with corrosion & oxidation agents. Mixture 100.0 Material Uses Chemical Formula Synonym(s) Product ID No. Name CAS # % by Weight Emergency Overview Section I. Chemical Product and Company Identification PEL/TLV, Source 5 mg/m3 (oil mist), OSHA LC50, LD50 of Ingredients Not available Mixture None 23132 Potential Health Effects: Skin Contact Eye Contact Ingestion Inhalation Section II. Composition and Information on Ingredients Section III. Hazards Identification Continued on Next Page Approval Date Supersedes Date 2/9/2009 6/28/2007 Prolonged or repeated skin contact may cause mild irritation. While this product has a low degree of toxicity, ingestion may cause irritation of the digestive tract. Not expected to present an inhalation exposure risk at ambient temperatures. If vapors or mists are created upon heating or by mechanical means, vapors or mists may be produced which may cause irritation of the breathing passages. Aspiration may cause pulmonary edema or aspiration pneumonia. Lubricant Potential health risks vary from person to person. As a precaution, exposure to liquids, vapors, mists or fumes should be minimized. May cause slight irritation and redness. Emergency Contact JAX: 262-781-8850 JAX/FAX: 262-781-3906 For Chemical Emergency, Spill, Leak, Fire, Exposure or Accident, Call CHEMTREC: NORTH AMERICA 800-424-9300 INTERNATIONAL +01-703-527-3887 Collect Non-Emergency Contact JAX INC. Continued on Next Page Eye Contact Skin Contact Inhalation Ingestion Flash Point Flammable Limits (Approx.) Products of Combustion 396°F (202°C) min., ASTM D 92 LOWER Flammable Limit: UPPER Flammable Limit: Not available Explosion Hazards Fire Fighting Media and Instructions Special Remarks - Fire and Explosion Hazards Release or Spill Environmental Impact Report spills as required to the appropriate authorities. U.S Coast Guard Regulations require immediate reporting of spills that could reach any waterway including intermittent dry creeks. Report spill to the Coast Guard toll-free number 800-424-8802. Handling Section VI. Accidental Release Measures Section VII. Handling and Storage Section V. Fire and Explosion Data Section IV. First Aid Measures See Lower and Upper Flammable Limits Autoignition Temperature PAGE 2 OF 4 Sensitivity to Impact Sensitivity to Static Discharge Not available Not available Not available Not available 1 1 0 HMIS Code Health: Fire: Physical Hazard: Section III. Hazards Identification (cont'd) Storage Remove sources of ignition. Recover free product. Add sand, earth, or other suitable absorbent material to the spill area. Minimize breathing vapors. Minimize skin contact. Open all windows and doors. Keep product out of sewers and watercourses by diking or impounding. Advise authorities if the product has entered or may enter sewers, watercourses, or extensive land areas. Remove contact lenses, if wearing, and flush eyes with water. If irritation persists, consult a physician. Remove clothing and shoes, if contaminated. Wash skin with soap and water. Wash or clean contaminated clothing before reuse and discard oil-soaked shoes. If irritation persists, consult a physician. If high pressure forces the product under the skin, get immediate medical attention! If swallowed, DO NOT induce vomiting. As a precaution, give the person a glass of water to drink and seek medical attention. Never give anything by mouth to an unconscious person. Consult a physician. If exposed to excessive levels of material in the air, move the exposed person to fresh air. Seek medical attention if coughing or respiratory discomfort occurs. Dry chemical, alcohol foam, and carbon dioxide type extinguishing agents may all be suitable for extinguishing fires involving this type of product, depending on the size or potential size of fire and circumstances related to the situation. Plan fire protection and response strategy through consultation with local fire protection authorities or appropriate specialists. The following procedures for this type of product are based on the recommendations in the National Fire Protection Association's Fire Protection Guide on Hazardous Materials. Use water to keep fire-exposed containers cool. If a leak or spill has not ignited, use water spray to disperse the vapors and to provide protection for men attempting to stop a leak. Water spray may be used to flush spills away from explosives. Firefighters should wear full protective gear, including helmet. Use supplied-air breathing equipment for enclosed or confined spaces or as otherwise needed. For fires involving this material, do not enter any enclosed or confined fire space without proper protective equipment, including self-contained breathing apparatus. Leaks/ruptures in high-pressure systems using materials of this type can create a fire hazard when in the vicinity of ignition sources (open flame, pilot lights, sparks or electric arcs). Do not use in high-pressure systems in the vicinity of flames, sparks, and hot surfaces. Keep container closed. Store in a cool, dry place. Do not store near heat, sparks, open flame, pilot lights, static electricity, or where temperature may exceed 120°F (49°C). Keep out of reach of children. Container is not designed to contain pressure. Do not use pressure to empty container or it may rupture with explosive force. "Empty" containers retain product residue and can be dangerous. Do not pressurize, cut, weld, braze, solder, drill, grind, or expose such containers to heat, flame, sparks, static electricity, or other sources of ignition as they may explode and can cause injury or death. Empty container should be promptly returned to a drum reconditioner. Electrically bond and ground all containers and equipment. JAX CRYOGUARD PLUS ISO 32 Carbon monoxide, carbon dioxide, smoke and irritating vapors as products of incomplete combustion. 0 Minimal Hazard 1 Slight Hazard 2 Moderate Hazard 3 Serious Hazard 4 Severe Hazard HAZARD RATINGS 700°F (371°C) <0.0001 Heavier than air ISO 32 = 0.8607; ISO 68 = 0.8686 Not available Nil Nil Clear lube oil with little or no odor Not available Not available PAGE 3 OF 4 JAX CRYOGUARD PLUS ISO 32 Respiratory Protection Ventilation Protective Gloves Eye Protection Engineering Controls Chemical splash goggles or face shield in compliance with OSHA regulations are advised when eye contact may occur. Personal Hygiene Section VIII. Exposure Controls and Personal Protection Exposure Limit Section IX. Physical and Chemical Properties Appearance/Odor Molecular Weight pH Boiling Point Freezing/Melting Point Specific Gravity Density Vapor Pressure Vapor Density Percent Volatile Evaporation Rate Viscosity Solubility in Water Not available Section X. Stability and Reactivity Data Stability Conditions and Materials to Avoid Hazardous Decomposition Products Hazardous Polymerization Stable under normal temperatures and pressures. Hazardous polymerization will not occur. Section XI. Toxicological Information Routes of Entry Toxicity to Animals Effects of Acute Exposure Acute Effects of Sensitization Ingestion Inhalation Dermal contact, eye contact, inhalation, ingestion. Chronic Effects on Humans: Carcinogenic Effects Not available Not available Not available Not available Physical State Odor Threshold Not available Coefficient of Water/Oil Distribution Not available Conditions of Reactivity Not available Toxically Synergistic Products Not available Continued on Next Page Liquid Not available Not available Mutagenic Effects This product does not contain a carcinogen or potential carcinogen as listed by NTP, IARC, or OSHA [29 CFR 1910.1200(D)#4]. Avoid heat, sparks, open flames and oxidizing materials. Carbon monoxide, carbon dioxide, smoke and irritating vapors as products of incomplete combustion. Not available Conditions of Instability Not available No data available to indicate any components present at greater than 0.1% may present a mutagenic hazard. Use respiratory protection if needed to keep airborne levels below recommended oil mist exposure limits. Use in a well-ventilated area. See Engineering Controls. Wear lined non-permeable rubber gloves. Wash skin thoroughly after contact, before breaks and meals and at end of work period. Product is readily removed from skin by waterless hand cleaners followed by washing thoroughly with soap and water. If user operations generate an oil mist, use process enclosures, local exhaust ventilation, or other engineering controls to keep airborne levels below the recommended oil mist exposure limits. See Section II. PAGE 4 OF 4 JAX CRYOGUARD PLUS ISO 32 Section XII. Ecological Information Ecotoxicity There is no data available on the adverse effects of this material on the environment. Section XIII. Disposal Considerations Waste Disposal Consult federal, state or local authorities for proper disposal and reporting procedures. All disposals must comply with federal, state and local regulations. Section XIV. Transportation Information U.S. D.O.T. Shipping Name: Hazard Class: UN Number: Packing Group: Remarks Section XV. Regulatory Information CERCLA SARA (Section 313) SARA Extremely Hazardous List TSCA Inventory California Prop. 65 U.S. Federal Regulations: Canada Japan MITI Australia Switzerland International Regulations: Section XVI. Other Information Approval Date All components of this material are on the U.S. TSCA Inventory. All components are in compliance with the Canadian Environmental Protection Act. This product has been classified in accordance with the hazard criteria of the CPR and this MSDS contains all the information required by CPR. Supersedes Date Sections Revised Since Last Version Prepared by Technical Services 262-781-8850 Not regulated None None None None None 2/9/2009 6/28/2007 Section I This product contains the following chemical(s) listed in Section 313 at or above the de minimis concentrations: Teratogenic Effects Reproductive Effects No data available to indicate any components present at greater than 0.1% may present a reproductive hazard. No data available to indicate any components present at greater than 0.1% may present a teratogenic hazard. Section XI. Toxicological Information (cont'd) Release of the following chemical(s) at quantities equal to or greater than the reportable quantities (RQ), is regulated by 40 CFR 302.4 : This product contains greater than 1.0% of the following chemical(s) on the SARA Extremely Hazardous Substances List: None Not available Not available Not available None None This product contains the following chemical(s) known to the State of California to cause birth defects or other reproductive harm: The information and recommendations contained herein are, to the best of JAX INC.'s knowledge and belief, accurate and reliable as of the date issued. JAX INC. makes no warranty or guarantee, expressed or implied, of their accuracy or reliability, and JAX INC. shall not be liable for any loss or damage based up on the criteria supplied by the developers of these rating systems, together with JAX INC.'s interpretation of the available data.
